Intertechno/Kappa dimmable transformer not supported?

Moderator: Telldus

Intertechno/Kappa dimmable transformer not supported?

Postby omicronCZ » Fri Jul 29, 2011 8:39 am

Why Intertechno/Kappa dimmable transformer (http://www.intertechno.at/produkte/empfaenger/dimmer/HDR-105.html) with Code Switch is not supported in TelldusCenter software?
Actually no dimmable actor (dimmer) with Code Switch are not supported...
A solution ? Thanks.
omicronCZ
 
Posts: 33
Joined: Fri Jul 29, 2011 8:27 am

Re: Intertechno/Kappa dimmable transformer not supported?

Postby micke.prag » Mon Aug 01, 2011 8:03 am

This is simply since the receiver doesn't support any dim-commands. You can still configure it as code switch and use it just like you can with the remote.
Micke Prag
Software
Telldus Technologies
micke.prag
Site Admin
 
Posts: 2136
Joined: Thu Jul 27, 2006 8:25 pm
Location: Lund

Re: Intertechno/Kappa dimmable transformer not supported?

Postby omicronCZ » Mon Aug 01, 2011 9:30 am

I do not understand, you mean that the dimmable transformer? It can of course use the normal (Kappa, Intertechno etc.) remote control continuously dimmed, but using "Tellstick" no. Because it is not in the software set up, just as You write, set it as the "On / Off" mode ... So I have now set, but unfortunately without dimming function.
Do you think it is "dim-commands" from "Tellstick" it can not send "Tellstick"? And it will be able to? What is the problem (software or Tellstick hardware) ?
omicronCZ
 
Posts: 33
Joined: Fri Jul 29, 2011 8:27 am

Re: Intertechno/Kappa dimmable transformer not supported?

Postby micke.prag » Tue Aug 02, 2011 6:46 am

The remote control only have two buttons, on and off. These "actions" is the only one the receiver understands. So these are the only ones TellStick can send.
To dim the receiver with the remote control you press the on-button twice, the receiver goes into dim-mode and starts dimming up and down. To stop the dim-cycle you just press the on-button again. You have to do the same thing with the TellStick. Press on twice to start the dimming and press on again when the receiver is in the right state.

Since the receiver doesn't understand any other signals this is the best we can do. The selflearning swithes on the other hand also understands "real" dimming commands. With those it is possible to send a "75% command" to the receiver.

The problem is the receiver, not TellStick.
Micke Prag
Software
Telldus Technologies
micke.prag
Site Admin
 
Posts: 2136
Joined: Thu Jul 27, 2006 8:25 pm
Location: Lund

Re: Intertechno/Kappa dimmable transformer not supported?

Postby omicronCZ » Tue Aug 02, 2011 7:10 am

Thanx.
omicronCZ
 
Posts: 33
Joined: Fri Jul 29, 2011 8:27 am


Return to Windows

Who is online

Users browsing this forum: No registered users and 1 guest